• Electrical Engineer - Early to Mid Career

    BAE Systems (Hudson, NH)


    Job Description

    We are seeking an early to mid-career Electrical Engineer to support our EO/IR seeker and precision munitions products and related technologies. If selected, you will be part of the Hardware Team supporting development programs in the Franchise Program Portfolio a major piece of our Precision Guidance and Sensing Solutions product line.

    Key Responsibilities:

    + Translate system requirements into successful system architectures and complex printed board assembly designs.

    + Create board schematic and layouts using Cadence Allegro System Capture

    + Perform trade studies and prototyping to down select critical components, develop optimized electronic architectural solutions (SWAP), verify complex custom circuit blocks of an overarching system

    + Document design verification tests and design review documentation

    + Actively participate in knowledge-sharing culture via mentoring

    + Work within schedule and budget constraints and elevate concerns if challenges arise.

    Required Education, Experience, & Skills

    + Bachelor s degree in Electrical Engineering

    + Minimum of four years of relevant experience in related industry (i.e. defense, electronics) or two years with a Master s Degree

    + Solid understanding of fundamentals of digital, analog, power, and mixed-signal electronics and interface/communication standards such as UART, SPI, QSPI, I2C, USB, Ethernet, ARINC 429, MIL-STD-1553, PCIe

    + PCB/CCA design experience, with an emphasis on DFA and DFM optimization, for complex rigid and rigid-flex mixed-signal HDI PCBs.

    + Proficient at testing and troubleshooting analog, digital, and power supply-based circuits in a lab setting using oscilloscopes, bench supplies, vector network analyzers, spectrum analyzers, frequency counters, arbitrary waveform generators, function generators, logic analyzers

    Preferred Education, Experience, & Skills

    + Master s degree in Electrical Engineering, RF Engineering, or equivalent

    + Familiarity designing with FPGAs, System-On-Chips (SoC), and/or CPLDs using VHDL and/or Verilog

    + Familiarity designing and writing embedded SW for microcontroller-based systems and modules

    + Knowledge of system level EMI mitigation techniques along with proper grounding/shielding architecture

    + Experience with high-speed mixed signal HDI PCB design, constraints management, and proper routing for interfaces with lane rates exceeding 1Gbps

    + Hands-on experience with high voltage testing with an emphasis on measurement safety

    + Experience with low noise, wide bandwidth, low power, Analog Front-End systems

    + Understanding of SPICE simulators and simulation methods, preferably using LTSpice, TINA, PSpice Experience with the following PCB and CCA design features: micro-via and blind/buried vias, stacked micro-vias, via-in-pad and via fill/cap processes, controlled impedances, backdrilling, high pin count / fine-pitch BGAs, Chip-on-Board (COB), QFNs/DFNs, LGAs, and other advanced IC package types

    + Familiarity with phase/gain margin stability analysis and other small signal analysis techniques, as it applies to analog circuit design and switch-mode power supply design

    + Familiarity with Signal Integrity and Power Integrity, as it applies to proper layout techniques

    + Active DoD Security Clearance Secret

     

    Pay Information

     

    Full-Time Salary Range: $95106 - $161680

     

    Please note: This range is based on our market pay structures. However, individual salaries are determined by a variety of factors including, but not limited to: business considerations, local market conditions, and internal equity, as well as candidate qualifications, such as skills, education, and experience.

     

    Employee Benefits: At BAE Systems, we support our employees in all aspects of their life, including their health and financial well-being. Regular employees scheduled to work 20 hours per week are offered: health, dental, and vision insurance; health savings accounts; a 401(k) savings plan; disability coverage; and life and accident insurance. We also have an employee assistance program, a legal plan, and other perks including discounts on things like home, auto, and pet insurance. Our leave programs include paid time off, paid holidays, as well as other types of leave, including paid parental, military, bereavement, and any applicable federal and state sick leave. Employees may participate in the company recognition program to receive monetary or non-monetary recognition awards. Other incentives may be available based on position level and/or job specifics.

     

    Electrical Engineer - Early to Mid Career

    117482BR

    EEO Career Site Equal Opportunity Employer. Minorities . females . veterans . individuals with disabilities . sexual orientation . gender identity . gender expression