• Machinist II - Cylindrical Grind - 1st Shift

    CIRCOR International, Inc. (Monroe, NC)


    Position Summary

    Semi and finish grind all ODs on rotors, shafts, ring gears, etc. Some toolroom grinding such as arbors and bushings.

     

    With own judgement and minimal directions from others, produce a quality ground rotor in a safe and efficient manner. Grind all diameters on all rotors, shafts, etc. Inspect sizes, lengths, finishes, radii, etc. Properly fill-out all paperwork, monitor coolant, and keep good housekeeping.

     

    Principal Activities

     

    Operate one, two, or more machines including: NCCG, CYC, lapper, etc. Use precision measuring equipment such as micrometer, dial caliper, profilometer, etc. to inspect rotor, shafts, ring gears, and various other parts. Operate electric or air-power crane/forklift.

    CANDIDATE REQUIREMENTS

    Lift, pull, and push. Continuously, walk or move from one machine to as many as three. Physically, load and unload parts. Deburr utilizing a file, or other hand tool such as die grinder. Clean parts and centers of chips and wipe dry. Physically, lift and check all dimensions, machine to conform with finish drawing. Make adjustment on machine as needed to produce quality parts within specifications and standards given/per piece. Utilize multi-function electric or air-crane (where available) to lift/move/load/unload parts, to perform workcenter functions. Step up to and down from elevator work platform and on to various parts of machine for wheel changes and cleaning.

    RESPONSIBILITIES

    Compliance with all rules and regulations, normal safety precautions. Work alone, recognize, and immediately correct machine difficulties or errors; or, cause to have corrected; if fault is due to machine tool, equipment, or material. Maintain a clean, safe, efficient work area. Maintain all paperwork as needed. Consistently produce work of proper quality and required quantity.

     

    Knowledge Skills & Abilities

     

    Must be able to read and follow detailed instructions. Must be able to fill out forms as needed such as: daily labor report, log sheet, etc. Use of mathematics, reading fairly complicated drawings, specifications, charts, etc

     

    Education & Experience

     

    HS Diploma - with 1-3 years machining experience preferred.

     

    Technical Degree in Machining a plus

     

    CIRCOR is an EEO Employer of Females / Minorities / Veterans / Individuals with Disabilities

    Equal Opportunity Employer/Protected Veterans/Individuals with Disabilities

    This employer is required to notify all applicants of their rights pursuant to federal employment laws. For further information, please review the Know Your Rights notice from the Department of Labor.