"Alerted.org

+ Responsible for properly setting-up and operating the drill, tapping arm, cage tools, counter sinks, and counter bores

+ Accurately read and interpret manufacturing/part blueprints

+ Accurately punch in and out of jobs via Infor Shop-Trak

+ Responsible for completing an in-process inspection. Identify non-conformances during inspection of component parts and properly document such non-conformances.

+ Responsible for notifying supervisor when work received by previous operators does not meet the specifications required

+ Maintain clean equipment, tools, and work area

+ Responsible to follow all relative ISO procedures

+ Follow established safety procedures

+ Work effectively in a team environment

+ Support and/or drive FVMT continuous improvement initiatives

+ Communicate and problem solve with others in a reasonable and professional manner

+ Carry out written, verbal, or diagrammatic instructions and solve practical problems

+ Perform basic arithmetic calculations

+ Ensure work area is kept clean to 6S standards

+ Demonstrate responsible behavior and attention to detail

+ Ensure the health and safety of oneself and others at all times, and communicate potential hazards to the appropriate personnel

+ Use drill fixtures to drill precision holes in tight areas

+ Understand how to counter bore, counter sink, tap holes, and properly measure each to verify the work performed is correct

+ Understand and perform basic grind and straightening techniques

+ Perform other duties as assigned by the supervisor

Education:

+ High school diploma or equivalent

Experience:

+ 2+ Years of experience with reading and working with technical blueprints, CAD drawings, or layouts is preferred

+ Knowledge of raw materials including steel, aluminum, and stainless steel is required

+ Ability to work in a fast-paced environment and produce high quality work is required

+ Reading, writing, and math skills commensurate with position is required

+ Experience successfully working alone as well as in a team setting is required

Specialized Experience:

+ Ability to utilize a drawing to set-up the tooling needed to process parts including proper selection of countersinks, counterbores, and taps

+ Ability to use appropriate measuring equipment needed to inspect parts to the customer requirements, including calipers and thread gauges

Physical Demands: The physical demands described below are representatives of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

While performing the duties of this job, the employee is required to:

+ Frequently: sit, grasp/hold, fine manipulation of both hands

+ Occasionally: reach at shoulder, lift/carry, and walk

+ Occasionally: stand, reach below shoulder, reach above shoulder

Percent of job performed per Hours Worked:

0% - 15% Seldom

16% - 33% Occasionally

34% - 65% Moderate

66% - up Frequently